Not every plumber is certified for gas work in MD. Our gas plumbers hold active state certifications for natural gas and propane installations, carry CSST-qualified training for flexible corrugated stainless steel tubing systems, and document every job with a written pressure test result before we close out.
๐ Call +1-855-718-1500 โ Certified Gas Plumbers
These aren't marketing points โ they're the minimum requirements for safe gas line work. Every Masters Plumbing Service gas job in Upperco, MD meets all four, on every call, without exception.
Gas plumbing in MD requires specific certifications beyond a standard plumbing license. Every technician we dispatch for gas work holds an active state certification for gas line installation and repair. We can provide license numbers and certification documentation before any work begins โ and we encourage you to verify them with the MD licensing board.
We also detector-test any existing connections near the work area that weren't disturbed, to confirm no pre-existing issues in the adjacent line.
A manometer measures gas line pressure precisely over a timed hold period. After any repair or new installation, we isolate the segment, pressurize to test pressure, connect the manometer, and hold for the required duration. Zero pressure drop confirms a leak-free installation. We document the test result โ pressure, hold time, and pass/fail โ and provide you with a copy.
A permit isn't just a bureaucratic step โ it's an independent safety check. The inspector confirms our work meets the applicable code. That second set of eyes protects you, and we welcome it.
Every job follows the same detection and pressure-testing standard regardless of scope.
If you smell gas โ the distinctive sulfur/rotten-egg odor added to natural gas for detection โ the immediate protocol is: leave the building without operating any switches, leave the door open, call your gas utility's emergency line from outside to shut off the street supply, then call us. Our certified gas plumbers arrive with combustible gas detectors to locate the exact source of the leak in service lines, appliance connectors, meter risers, or distribution piping inside the structure.
Flexible corrugated stainless steel tubing (CSST) connections require proper bonding in most MD jurisdictions to prevent damage from nearby lightning events โ a code requirement many contractors overlook. Our gas techs are CSST-bonding trained.
Adding a gas barbecue outlet, running gas to a new range or cooktop, extending gas to an outdoor kitchen or pool heater, or adding a gas stub for a whole-house generator โ all require a new gas line run sized correctly for the BTU demand of the connected appliances and the existing line's supply pressure.
A standalone gas system pressure test โ without any repair or installation โ is requested for several reasons: before purchasing a home with gas appliances, when an unexplained gas smell has been investigated and not found but a homeowner wants confirmation the system is sound, or at a contractor's request before final inspection.
If you have CSST in your home and it was installed before 2010, the bonding may not meet current code requirements. We can assess existing CSST installations, add required bonding conductors, and document the system for insurance or resale purposes.
{Propane systems used in areas of Upperco, MD without natural gas service have specific considerations compared to natural gas: different line pressures at the regulator (propane distribution pressure varies by system design), different BTU content per cubic foot, and propane's behavior of settling low (it's heavier than air, so propane accumulates at floor level rather than rising to ceilings).|We service propane supply lines from the tank to the structure, appliance connections, regulator function checks, and leak detection using detectors calibrated for propane's lower explosive limit.}
Gas line work follows a defined protocol โ no steps skipped, no "close enough." Here's exactly how a Masters Plumbing Service gas call runs from your first contact to a documented, pressure-tested result.
Active gas smell: stay out of the building, call your utility to shut street supply, then call us. Non-emergency gas work (new runs, appliance connections, pressure testing): call to schedule โ we confirm certification documentation and permit requirements for your specific job scope before arrival.
For new installation work, we assess the existing supply line pressure, measure the BTU demand of the new appliances, and calculate the required pipe diameter for the new run before quoting.
For leak repairs, the gas remains off on the affected line until the repair is complete, the detector passes every joint, and the manometer test confirms a leak-free system.
After every gas job โ repair, new run, or appliance connection โ we conduct a timed manometer pressure hold test on the affected segment and detector-test every connection point. You receive the written test result as part of your job documentation.

Needed a new gas line run to an outdoor kitchen setup. Masters Plumbing Service sized the line correctly for the combined BTU load of the burners and the side burner, ran 3/4-inch black iron through the crawl space and up through the exterior wall, installed a shutoff at the outlet, pressure tested the new segment, and handled the permit and inspection scheduling. Inspection passed first time.
I bought an older home in Upperco that had a gas dryer stub but I'm switching to a gas range. Masters Plumbing Service traced the existing gas distribution, confirmed the supply capacity was adequate, extended the run to the kitchen with correctly sized pipe, capped the dryer stub, and provided a full manometer test on the entire modified system. Very thorough work โ documentation exactly as described upfront.
Commercial kitchen remodel required moving two gas lines and adding a new connection for a salamander broiler. Masters Plumbing Service sized the header and branch lines for the total connected BTU load, pulled the required commercial permit, executed the work, and provided a full system pressure test documentation for the health department inspection file. Clean work, inspected and passed first visit.

Masters Plumbing Service dispatches certified gas plumbers throughout Upperco and the broader Upperco, MD service area. Emergency gas response is available around the clock โ non-emergency work is scheduled with permit lead time in mind.

Gas line work done right means certified technicians, combustible gas detection at every connection, and a manometer pressure test before gas is restored. Masters Plumbing Service delivers all three on every gas call in Upperco, MD โ emergency or scheduled.
๐ Call +1-855-718-1500 Now